Product Reference Guide
325
Appendix C
Standard Defaults
The most common configuration settings are listed in the “Default” col-
umn of the table below. Page references are also provided for feature
descriptions and programming bar codes for each parameter. A column
has also been provided for recording of your preferred default settings
for these same configurable features.
Table 50. Standard Defaults
Parameter Default Your Setting
Page
Number
GLOBAL INTERFACE FEATURES
Host Commands — Obey/Ignore
Obey 25
RS-232 ONLY
Baud Rate
115200 28
Stop Bits
1 Stop Bit 29
Parity
None 29
Handshaking Control
RTS 30
RS-232/USB-Com
Intercharacter Delay
No Delay 32
Beep On ASCII BEL
Disable 32
Beep On Not on File
Enable 33
ACK NAK Options
Disable 34
ACK Character
‘ACK’ 35
NAK Character
‘NAK’ 35
ACK NAK Timeout Value
200 ms 36
ACK NAK Retry Count
3 Retries 37
ACK NAK Error Handling
Ignore Errors Detected 38
Indicate Transmission Failure
Enable 38
To Next Page
Loading...
