Datalogic PowerScan PD9531-AR - Intercharacter Delay

Enter/Exit Programming Mode
32 PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one
character and the beginning of the next. The delay can be set within a range
of zero (0) to 990 milliseconds in 10ms increments. A setting of zero speci-
fies no delay.
See page 287 for more information.
Intercharacter Delay = No Delay
Select Intercharacter Delay Setting
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
Appendix D, Keypad repre-
senting your desired character(s). End by scanning
the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
a
nd not save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
00 = No Intercharacter Delay