Enter/Exit Programming Mode
Product Reference Guide
245
Base Address Stamping
Enables/disables the ability of base address information to be transmitted
to the host and, if so, at what position with respect to the label data. See
page 304 in “References” for detailed information and examples for setting
this feature.
DEFAULT
Base Address Transmission = Do Not Include
Base Address Transmission = Prefix
Base Address Delimiter Character
This option specifies the delimiter character to be placed between the label
data and base address when address stamping is enabled.
Set Base Address Delimiter Character
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by two digits from the Alphanu-
meric characters in
Appendix D, Keypad
repre-
senting your desired character. End by scanning the
ENTER
/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start
again at the beginning.
CANCEL
DEFAULT
00 = No Delimiter Character
This feature only applies if
"Base Address Stamping"
on
page 245 is enabled.
To Next Page
Loading...
Need help?
General
