Enter/Exit Programming Mode
Product Reference Guide
253
Display Contrast
Adjust the contrast of the display.
Set Display Contrast
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code at left followed by two digits (00-32 by 01) from
the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT
bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start
again at the beginning.
CANCEL
Font Size
Select the font size.
DEFAULT
Font Size = Small
Font Size = Medium
Font Size = Large
To Next Page
Loading...
