Enter/Exit Programming Mode
Product Reference Guide
47
Intercode Delay
Specifies the delay between labels transmitted to the host for this interface.
The selectable range for this feature is from 0 to 99 seconds.
See page 288 in “References” for detailed information and examples for set-
ting this feature.
Set Intercode Delay
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then
the bar code at left followed by the digits from
the Alphanumeric characters in
Appendix D,
Keypad
representing your desired character(s).
End by scanning the ENTER/EXIT bar code
aga
in.
Make a mistake? Scan the CANCEL bar code to
a
bort and not save the entry string. You can
then start again at the beginning.
CANCEL
DEFAULT
00 = No Wedge Intercode Delay
To Next Page
Loading...
Need help?
General
