DEFAULT
F2 No Actions Configured
Configure Actions for F2
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE bar code above, then the bar
code for the Function Key you want to program. Next
scan 4 digits from the Alphanumeric characters in
Appendix D, Keypad
.
The first digit must be 0; the following 3 digits must
be con
figured according to the CMD_ID numbers in
Table 27 on page 257
. End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not
save the entry string. You can then start
again at the beginning.
CANCEL
Enter/Exit Programming Mode
Product Reference Guide
259
Configure Actions for F2
To Next Page
Loading...
Need help?
General
