Enter/Exit Programming Mode
24
PowerScan™ PD9531-AR/PBT9501-AR/PM9501-AR
Symbology-specific parameters:
• "1D Symbologies" on page 83 provides configuration of a personalized
mix of 1D codes, code families and their options.
• "2D Symbologies" on page 175 provides configuration of a personal-
ized mix of 2D codes, code families and their options.
You must first enable your reader to read bar codes in order to
use this section. If you have not done this, go to
Setup, starting on page 7
and complete the appropriate
procedure.
To program features:
1. Scan the ENTER/EXIT PROGRAMMING bar code, available at the top of
each programming page, when applicable.
2. Scan the bar code to set the des
ired programming feature. You may
need to cover unused bar codes on the page, and possibly the facing
page, to ensure that the reader reads only the bar code you intend to
scan.
3. If additional input parameters ar
e needed, go to Appendix D, Keypad,
and scan the appropriate characters from the keypad.
Additional information about many features can be found in the
“References” chapter.
If you make a mistake before the la
st character, scan the CANCEL
bar code to abort and not save the entry string. You can then start
again at the beginning.
4. Complete the programming sequence by scanning the ENTER/EXIT
PROGRAMMING bar code to exit Programming Mode.
For more detailed descriptions, progr
amming information and examples for
setting selected configuration items, see References, starting on page 277.
To Next Page
Loading...
