EasyManuals Logo

Datalogic PowerScan RF Programming Guide

Datalogic PowerScan RF
220 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #156 background imageLoading...
Page #156 background image
150 PowerScan
®
RF Scanner
Linking the
Scanner to a
Base Station
To link a scanner to a Base Station, simply scan the Base Station ID bar
code located on the top of the desired Base Station (see Figure 2). As the
scanner searches for the Base Station, a short beep is heard as it seeks
for the correct channel. When the Base Station responds to the request,
the scanner’s beeper will either sound a "Link Granted," or "Link
Denied" signal (see Appendix E: LED and Beeper Indications on page 203
for more information).
The existing Base Station system configuration can be automatically
downloaded to the scanner. This automatic download feature is config-
urable and can be disabled. See the section, Common Configuration for
more information about this feature. If downloading occurs, a slight
delay with link verification announcement will occur.
Figure 2. The Base ID Bar Code
CAUTION
Since a new/replacement scanner may have been
shipped with a custom configuration or may have
been modified with other special programming, it
may not be desirable to download a potentially
older configuration from an existing Base Station.
In this case, reference Transmit Scanner Configura-
tion to Base Station on page 11 and consider
uploading the scanner’s newer configuration to the
Base Station.
BASE ID
TX/RX
CHARGE
POWER
Base ID Bar Code

Table of Contents

Other manuals for Datalogic PowerScan RF

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datalogic PowerScan RF and is the answer not in the manual?

Datalogic PowerScan RF Specifications

General IconGeneral
BrandDatalogic
ModelPowerScan RF
CategoryBarcode Reader
LanguageEnglish

Related product manuals