Datalogic PowerScan RF Programming Guide

RF Programming Manual 27
Baud Rate Use the bar codes on this page to select the communications Baud Rate.
Only one Baud Rate selection may be active at any one time. The last
Baud Rate label you scan during a programming session will be the set-
ting that is stored when you scan the END label.
SET ---------------------------
Baud Rate =
1200 ---------
Baud Rate =
2400 ---------
Baud Rate =
4800 ---------
Baud Rate =
9600 ---------

Datalogic PowerScan RF Specifications

General

Brand	Datalogic
Model	PowerScan RF
Category	Barcode Reader
Language	English