Datalogic PowerScan RF Programming Guide

RF Programming Manual 195
Appendix D: Record of Programmable Features
Maintain a record of all changes made to ensure that you know if the
original factory settings have been changed. Use the following table to
log your custom configuration changes.
NOTE
The factory default settings listed below represent
the most common settings used. There are some
customer-specific PowerScan configuration set-
tings that differ from the defaults listed.
Table 8
Programmable
Feature
Factory
Default
Setting
Your
Setting
Comment
Interface Selection
Wand Emulation (If enabled)
Polarity
Space low/
Bar High
Signal Speed High
Data Format Normal
Idle State Low
Pre-Noise None
Post-Noise 7
Transmit C128 Func-
tion Characters
Disable
RS-232 Interface (If enabled)
Baud Rate 9600
Data Bit 8
Parity Bit No Parity

Datalogic PowerScan RF Specifications

General

Brand	Datalogic
Model	PowerScan RF
Category	Barcode Reader
Language	English