RF Programming Manual 23
Wand
Emulation Pre-/
Post-Noise
Settings
The number of noise transitions generated prior to or following label
transitions are independently configurable options. To set noise transi-
tions, enter Programming Mode by scanning the SET bar code, then
follow these steps.
1. Scan Don’t Transmit Pre-Noise or Don’t Transmit Post-Noise,
followed by the END bar code to disable noise transitions, or...
2. Scan the Set Pre- or Post-Noise Transitions bar code followed
by the digits from Appendix C: Keypad that represent the
desired number of noise transitions. Select from one to twenty
1
noise transitions for either pre- or post-noise. Complete the
programming sequence by scanning the END bar code.
Feature is specific to Base Station ONLY
1. Scanners built prior to February of 2001 MUST select the digit one (1). See the note on this page
for details.
NOTE
Settings for this feature have been enhanced
since the product was originally released, add-
ing the option to select a specific quantity of
noise transitions. If your scanner was built prior
to February of 2001, pre-noise/post-noise tran-
sitions are enabled by following Step 2 above,
EXCEPT the single digit selected from Appen-
dix C: Keypad MUST be one (1). This will either
set the pre-noise transitions to one or the post-
noise transitions to three depending on which
feature is being programmed. The feature is dis-
abled in the same manner as Step 1 above.
To Next Page
Loading...
Need help?
General
