Datalogic PowerScan RF - Low Power Shut-Down Delay

186 PowerScan
®
RF Scanner
Low Power
Shut-down
Delay
This feature allows for quick successive reads in the Low Power Mode.
Low Power Shut-down Delay (LPSD) is the amount of delay after the
trigger is released before the scanner transitions into shut-down. The
programming bar codes below provide for transition times of 0 (no
delay), 2, 5, or 10 seconds delay.
For other LPSD settings contact your sales or service representative.
Scan these bar codes to set the LPSD option.
1. Scan the SET bar code.
2. Scan the bar code for delay desired.
3. Scan the END bar code.
SET ------------------------------------------
0 Seconds (No Delay) ---------
2 Seconds ---------
5 Seconds ---------
10 Seconds ---------
END ------------------------------------------