Datalogic PowerScan RF - Configuring the Standard 2 of 5 Options

134 PowerScan
®
RF Scanner
Configuring
the Standard 2
of 5 Options
Use the special bar codes in this section to configure the Standard
2 of 5/IATA symbology options.
Standard 2 of 5 options are all applicable only to the scanner,
with the exception of Check Digit Transmission, which applies
only to the Base Station.
Check Digit
SET -------------------------------
Don’t Calculate ---------
Calculate ---------
Don’t Transmit ---------
Transmit ---------
END ------------------------------
Transmit Scanner
Configuration to
Base Station ---------