12 PowerScan
®
RF Scanner
4. Download the new scanner’s configuration to the Base Station
by scanning the Transmit Scanner Configuration to Base Station
bar code below.
What Is
Programming
Mode?
The scanner must be placed into the Programming Mode state in order
to accept programming commands. When programming using the bar
code labels in this manual, the scanner is placed in Programming Mode
by scanning the "SET" label at the top of most programming feature
pages.
While in Programming Mode, the scanner only recognizes special pro-
gramming bar codes. See the Appendix E: LED and Beeper Indications on
page 203 for information about scanner indications while in Program-
ming Mode.
CAUTION
After the Base Station receives the entire configura-
tion, it will drop all links to scanners other than the
scanner transmitting the new configuration. This
will require the user to relink all other scanners (see
Linking the Scanner to a Base Station on page 150).
Prior to the time of relinking, it is advisable to con-
sider enabling the feature, Common Configuration
on page 174, ensuring that the Base Station will
attempt to share the new configuration with scan-
ners as they are linked.
Transmit Scanner
Configuration to Base
Station ---------
To Next Page
Loading...
Need help?
General
