152 PowerScan
®
RF Scanner
ACK Beep — The scanner can sound an acknowledgement (ACK)
beep to indicate when the Base Station has acknowledged to the scan-
ner that is has received a successful data transmission from the scanner.
This beep is also sounded upon a successful channel change sequence
or a successful configuration transmission.
Transmission Error Beep — Another selectable indicator beep is the
transmission error beep. This beep sounds to indicate an error in trans-
mission between the RF devices.
Link Beep — The handheld scanner will sound a special link beep
upon successfully linking with a Base Station. This indication cannot be
disabled and is not programmable, other than that it shares the same
Beeper Volume setting as other beeper indications set using that fea-
ture.
Unlink Beep — When a scanner is successfully unlinked from a Base
Station, a unique unlink beep is sounded. This beep is not programma-
ble, and also sounds at the same volume set for Beeper Volume.
RF When to
Beep
Several options are available to specify how the RF handheld scanner
will beep to indicate a good read. Settings are based on the enable/dis-
able status desired for three selectable beep indications:
• Good Read Beep
• Acknowledgement (ACK) Beep
• Transmission Error Beep
The available options are described and numbered in Table 7 to corre-
spond with the programming bar codes provided for this feature.
Feature is specific to scanner ONLY
NOTE
These settings supersede any settings made using
the generic "When to Beep" feature listed in the
PowerScan Programming Manual.
To Next Page
Loading...
Need help?
General
