Datalogic PowerScan RF - Transmission Retries Before Message Time-out

52 PowerScan
®
RF Scanner
IBM Interface
The IBM Group supports:
• Port 5B•Port 17•Port 9B•Port E
Scan the SET bar code to enter the programming mode, then scan the
programming bar code below to activate the desired interface, fol-
lowed by the END bar code to exit the programming mode and reset
the scanner.
Feature is applicable to scanner and Base Station.
SET -----------------------------
Enable Port 5B ---------
Enable Port 9B ---------
Enable Port 17 ---------
Enable Port E ---------
END ----------------------------
Transmit Scanner
Configuration to
Base Station ---------