EasyManuals Logo

Datalogic PowerScan RF Programming Guide

Datalogic PowerScan RF
220 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #66 background imageLoading...
Page #66 background image
60 PowerScan
®
RF Scanner
5. Scan the END bar code. You have added a two character suffix
to all bar code data, regardless of label symbology, that will be
added to the label data before it is sent to the host
Single
Character
Prefix or Suffix
The scanner will not transmit a prefix or suffix character if its hex value
is set to zero. To set a prefix or suffix that has only one character, follow
these steps:
1. Scan the SET bar code on page 62.
2. Scan SET PREFIX or SET SUFFIX bar code.
3. Turn to the keypad (Appendix C: Keypad on page 193) and scan
the two-digit hex code that represents your desired character
(refer to the ASCII chart on the inside back cover of this man-
ual for this conversion).
4. Scan the digit ‘0’ two times to disable transmission of a second
character.
Setting Global Suffix(es)
SET -------------------------------
Set Suffix ---------
Tur n to Appendix C: Keypad on page 193, and scan the four digits corresponding
to the Hex Values determined in step one above.
END ------------------------------
Transmit Scanner
Configuration to
Base Station ---------

Table of Contents

Other manuals for Datalogic PowerScan RF

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datalogic PowerScan RF and is the answer not in the manual?

Datalogic PowerScan RF Specifications

General IconGeneral
BrandDatalogic
ModelPowerScan RF
CategoryBarcode Reader
LanguageEnglish

Related product manuals