RF Programming Manual 11
Transmit
Scanner
Configuration
to Base Station
There are two reasons why a scanner’s configuration would need to be
downloaded to a Base Station:
• A configuration item affecting the Base Station is to be
changed.
• A new/replacement scanner may have a custom configuration
or may have been modified with special programming. It may
be desirable to download its configuration to the Base Station.
If this is the circumstance, download configuration settings
from a scanner to the Base Station following this procedure:
1. Using a scanner that is currently linked to the Base Station,
scan the bar code, DISABLE Common Configuration on page 175.
2. Scan the bar code, Transmit Scanner Configuration to Base Sta-
tionTransmit Scanner Configuration to Base Station on page 11.
3. Link the new scanner containing the desired configuration to
the Base Station (see Linking the Scanner to a Base Station on
page 150).
Feature is applicable to scanner and Base Station.
NOTE
When configuring the system using programming
bar codes, changes will not be implemented in the
Base Station until they are transmitted from the
scanner using the Transmit Scanner Configuration
to Base Station bar code.
To Next Page
Loading...
