RF Programming Manual 165
The range for this delay is 0.08 - 2.55 seconds in 10ms increments.
NOTE
Selecting longer values for this feature will
decrease the battery life between charges.
SET ------------------------------
Set Wait Time for
ACK ---------
Scan three digits representing the desired delay using the Number
Pad in Appendix C: Keypad. Be sure the number is padded with
leading zeros (example: 008 = 80ms, 025 = 250ms, 100 = 1 second,
etc.), then scan the END bar code.
END ------------------------------
Transmit Scanner
Configuration to
Base Station ---------
To Next Page
Loading...
