EasyManuals Logo

Datalogic PowerScan RF Programming Guide

Datalogic PowerScan RF
220 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
32 PowerScan
®
RF Scanner
Handshaking controls are mutually exclusive. The settings below
allow only one of these features to be enabled at a time, as enabling
multiple controls will produce unpredictable results.
Scan the SET bar code label then the Step #1, Step #2 below, followed
by the END bar code labels to enable CTS/RTS Flow Control.
NOTE
Each of the handshaking features requires a
series of bar codes to be read (Step #1, Step
#2) in the sequence given. That is, you must
enter Programming Mode by scanning the
SET bar code, scan the bar codes required to
set one handshaking feature, then scan the
END bar code.
Enable CTS/RTS Flow Control
SET ------------------------------
Step #1 ---------
Step #2 ---------
END -----------------------------
Transmit Scanner
Configuration to
Base Station ---------

Table of Contents

Other manuals for Datalogic PowerScan RF

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Datalogic PowerScan RF and is the answer not in the manual?

Datalogic PowerScan RF Specifications

General IconGeneral
BrandDatalogic
ModelPowerScan RF
CategoryBarcode Reader
LanguageEnglish

Related product manuals