RF Programming Manual 93
Set Second Fixed Length - instructs the scanner that the next
two programming labels scanned will define the second fixed
label length. This setting can be any even number of characters
between 02 and 50
1
characters.
No Second Fixed Length - configures the scanner to recognize
only the first fixed length.
Read
Verification
Read Verification is the number of times the scanner is required to read
the bar code data before sending the label data to the host.
QuadraLogic
™ II
Decoding
QuadraLogic™ II Decoding directs the scanner to decode labels with
widespread problems of spots, void, and/or non-uniform widths.
To optimize your scanner’s performance activate this option only for
symbologies for which it is necessary.
There are many additional ways to configure the scanner to read and
decode extremely poor labels. Contact your sales representative or ser-
vice provider for other advanced QuadraLogic™ II Decoding settings.
1. For this symbology, the scanner will decode up to 50 characters, but the actual length read will
vary depending upon the interface type, and bar code physical size and quality.
To Next Page
Loading...
Need help?
General
