Dell EMC DSS8440 - System Board and Power Interposer Board; Removing the System Board and Power Interposer Board

Next steps
1 Reconnect all cables to the system board tray module.
2 Install the following:
a Processor and heat sink
b Memory
c Riser 1 module
d Riser 2 module
e Buttery module
f GPU support bracket
g GPU card
h Air shroud
i System cover
3 Follow the procedure listed in After working inside your system
System board and power interposer board
Removing the system board and power interposer board
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the system cover.
4 Remove the air shroud.
5 Remove the system board tray module.Remove the system board tray module.
Steps
1 Remove the eighteen screws securing the system board and power interposer board to the system board tray.
2 Remove the one screw securing the system board handle to the system board.
3 Lift the system board and power interposer board from the system board tray module.
Installing and removing system components
79