Dell EMC DSS8440 - Handle; Removing the Handle

Steps
1 Install the fan cable to the fan cage.
2 Install the fan cage to the power distribution board.
3 Tighten the sixteen screws to secure the fan cage to the system chassis.
Figure 75. Installing the fan cage
Next steps
1 Connect the fan cable to the PSB power interposer board.
2 Install the following:
a Install the front control module.
b System board tray module.
c Air shroud
d PCIe switch board module.
e System cover
3 Follow the procedure listed in After working inside your system
Handle
Removing the handle
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
Steps
1 Unlock the handle by plunger.
2 Remove the handle from the chassis.
Installing and removing system components
93