Next steps
Replace the sled.
NOTE: If the sled is not being replaced immediately, a sled blank must be installed to ensure proper cooling of the system.
System cover
Removing the system cover
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Power off the system and all attached peripherals.
4. Disconnect the system from the electrical outlet and disconnect the peripherals.
Steps
1. Press and hold the cover release latch lock down.
2. With your palm on one of the traction pads, slide the system cover toward the rear of the system.
3. Lift the cover from the system.
Figure 26. Removing the system cover
Next steps
Replace the system cover.
30
Installing and removing system components
To Next Page
Loading...
