Installing the system cover
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Ensure that all internal cables are connected and routed properly, and no tools or extra parts are left inside the system.
Steps
Align the tabs on the system cover with the guide slots on the system and slide the system cover toward the front of the
chassis until it locks into place.
Figure 27. Installing the system cover
Next steps
1. Reconnect the peripherals, and connect the system to the electrical outlet.
2. Power on the system, and all attached peripherals.
3. Follow the procedure listed in After working inside your system.
Mid top cover
Removing the mid top cover
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Using the Phillips 1 screwdriver, remove the screws securing the mid top cover.
Installing and removing system components
31
To Next Page
Loading...
