Figure 33. Installing the diskless 80 mm fan cage
Next steps
Follow the procedure listed in After working inside your system.
Removing the 60 mm cooling fan cage
Prerequisites
WARNING: Do not attempt to operate the system without the cooling fans.
WARNING: The cooling fan spins for some time after the system is powered down. Allow the fan to stop
spinning before removing it from the system.
NOTE: Observe the routing of the cables when removing them from the system. Route these cables properly when you
replace them to prevent the cables from being pinched or crimped.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the system cover.
4. Remove the mid top cover.
Steps
1. Disconnect the fan power cable from the chassis management board.
2. Lift the cooling fan cage out of the chassis.
Installing and removing system components
37
To Next Page
Loading...
