Figure 82. Installing the left examax connector
Next steps
1. Install the 60 mm cooling fan cage.
2. Follow the procedure listed in After working inside your system.
Removing the right examax connector
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove all the sleds from the enclosure.
4. Remove the 60 mm fan cage.
Steps
1. Disconnect the examax cable from the backplane.
2. Using the Phillips 1 screwdriver, remove the screws that secures the examax connector to the enclosure.
3. Lift the examax connector out of the enclosure.
Installing and removing system components
79
To Next Page
Loading...
