Figure 37. Installing a 60 mm cooling fan
Next steps
1. Install the 60 mm cooling fan cage.
2. Follow the procedure listed in After working inside your system.
3. Check the management software to see if the fan is rotating at the optimal speed.
Removing the 40 mm fan cage
Prerequisites
WARNING: Do not attempt to operate the system without the cooling fans.
WARNING: The cooling fan spins for some time after the system is powered down. Allow the fan to stop
spinning before removing it from the system.
NOTE: Observe the routing of the cables when removing them from the system. Route these cables properly when you
replace them to prevent the cables from being pinched or crimped.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the system cover.
Steps
By holding the blue tab on the fan cage, lift up the fan cage from the fan cage holder.
Installing and removing system components
41
To Next Page
Loading...
