Figure 95. Removing the backplane
Next steps
1. Install the backplane.
Installing the backplane
Prerequisites
CAUTION:
You must note the slot number of each drive and temporarily label them before removal so that you
can replace them in the same slots.
NOTE: Observe the routing of the cables on the chassis as you remove them from the system. You must route these cables
properly when you replace them to prevent the cables from being pinched or crimped.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the drive cage.
Steps
1. Place the backplane on the drive cage, aligning the screw holes on the backplane with the holes on the drive cage.
2. Using the Phillips 2 screwdriver, tighten the screws to secure the backplane to the drive cage.
Installing and removing system components
89
To Next Page
Loading...
