Figure 41. Installation of the 40 mm fan cage holder
Next steps
1. Install the 40 mm fan cage.
2. Install the system cover.
3. Follow the procedure listed in After working inside your system.
4. Check the management software to see if all the fans are rotating at the optimal speed.
Thermal sensor board
This is a service technician replaceable part only.
Removing the thermal sensor board
Prerequisites
NOTE:
Observe the routing of the cables on the chassis as you remove them from the system. Route these cables properly
when you replace them to prevent the cables from being pinched or crimped.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the system cover.
4. Remove the mid top cover.
5. Remove all the 80 mm fans.
6. Remove the diskless 80 mm fan cage.
Steps
1. Using the Phillips 2 screwdriver, remove the screw securing the thermal sensor board to the diskless 80 mm fan cage.
2. Disconnect the sensor cable from the right midplane.
Installing and removing system components
45
To Next Page
Loading...
