Parameters
sequence-
number
Enter a number from 1 to 65535.
permit Enter the keyword permit assign the sequence to the
permit list.
redirect Enter the keyword redirect to assign the sequence to the
redirect list.
ip-address Enter the IP address of the forwarding router.
ip-protocol-
number
Enter the keyword ip-protocol-number then the number
from 0 to 255 for the protocol identified in the IP protocol
header.
protocol-type Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
• tcp for transmission control protocol
• udp for user datagram protocol
source Enter the IP address of the network or host from which the
packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all traffic is subject to
the filter.
host ip-address Enter the keyword host then the IP address to specify a host
IP address.
destination Enter the IP address of the network or host to which the
packets are sent.
bit (OPTIONAL) For the TCP protocol type only, enter one or a
combination of the following TCP flags:
• ack = acknowledgement
• fin = finish (no more data from the user)
• psh = push function
• rst = reset the connection
• syn = synchronize sequence number
• urg = urgent field
operator (OPTIONAL) For the TCP and UDP parameters only. Enter
one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt= less than
1052
Policy-based Routing (PBR)
To Next Page
