Dell S6000 - Description

Defaults Soft forwarding is enabled.
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL
Switch.
Usage
Information
All the default catch-all entries in the longest prefix match (LPM) table collect and
transmit all unresolved IPv6 packets to the CPU, even if they are destined for
unknown destinations.
description
Enables you to specify a descriptive name for a customer VRF.
S6000
Syntax
description string
To delete the descriptive name for a customer VRF, use the no description
string command.
Parameters
string Enter a descriptive name for the VRF.
Defaults None.
Command
Modes
VRF MODE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series.
Usage
Information
Use this command to specify a descriptive name for a VRF.
1448
Virtual Routing and Forwarding (VRF)