Related
Commands
redistribute — redistributes routes into BGP.
network backdoor
Specify this IGP route as the preferred route.
S6000
Syntax
network ip-address mask backdoor
To remove a network, use the no network ip-address mask backdoor
command.
Parameters
ip-address Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length
format (for example, /24).
The mask appears in command outputs in dotted decimal
format (A.B.C.D).
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
Although Dell Networking OS does not generate a route due to the backdoor
config, there is an option for injecting/sourcing a local route in the presence of
network backdoor config on a learned route.
Border Gateway Protocol
389
To Next Page
Loading...
