Dell S6000 - Snmp-Server Enable Traps

Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
snmp-server enable traps
Enable SNMP traps.
S6000
Syntax
snmp-server enable traps [notification-type] [notification-
option]
To disable traps, use the no snmp-server enable traps [notification-
type] [notification-option] command.
Parameters
notification-
type
Enter the type of notification from the following list:
• bgp — Notification of changes in the BGP process.
• config — Notification of changes to the startup or
running configuration.
• ecfm — Notification of changes to ECFM.
• ecmp — Enable an ECMP trap to notify of ECMP or link
bundle traffic imbalances.
• envmon — For Dell Networking device notifications when
an environmental threshold is exceeded.
• isis — Notification of intermediate service traps.
• lacp — Notification of changes.
• snmp — Notification of RFC 1157 traps.
• stp — Notification of a state change in the spanning tree
protocol (RFC 1493).
• vlt — Notification of virtual link trunking.
• vrrp — Notification of a state change in a VRRP group.
• xstp — Notification of a state change in MSTP (802.1s),
RSTP (802.1w), and PVST+.
notification-
option
For the envmon notification-type, enter one of the following
optional parameters:
• cam-utilization
• fan
1340
Simple Network Management Protocol (SNMP) and Syslog