Dell S6000 - 54 Virtual Routing and Forwarding (VRF)

54
Virtual Routing and Forwarding (VRF)
Virtual Routing and Forwarding (VRF) allows multiple instances of a routing table to co-exist on the same
router at the same time. Virtual Routing and Forwarding (VRF) is supported on the S-Series platforms.
ip unknown-unicast
Enable IPv4 catch-all route.
S6000
Syntax
ip unknown-unicast [vrf vrf-name]
To remove the IPv4 catch-all route (0.0.0.0/0) from the LPM route forwarding
table in hardware which gets added as a default configuration after the initialization
of FIB Agent module, use the no ip unknown-unicast command.
Defaults None
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of
the VRF to enable catch-all routes corresponding to that
VRF.
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0) Introduced on the S–Series.
Usage
Information
Use this command to add the IPv4 catch-all route (0.0.0.0/0) in the LPM route
forwarding table if it was deleted using the no ip unknown-unicast command
previously. This will be the default configuration after reload.
ipv6 unknown-unicast
Disable soft forwarding of unknown IPv6 destination packets.
S6000 MXL Switch
Syntax
[no] ipv6 unknown-unicast
Virtual Routing and Forwarding (VRF)
1447