Dell S6000 - 58 Virtual Router Redundancy Protocol (VRRP)

58
Virtual Router Redundancy Protocol
(VRRP)
Virtual router redundancy protocol (VRRP) is supported by the Dell Networking operating system on the
S6000 platform.
IPv4 VRRP Commands
The following are IPv4 VRRP commands.
advertise-interval
Set the time interval between VRRP advertisements.
S6000
Syntax
advertise-interval {seconds | centisecs centisecs }
To return to the default settings, use the no advertise-interval command.
Parameters
seconds Enter a number of seconds. The range is from 1 to 255. The
default is 1 second.
centisecs
centisecs
Enter the keyword centisecs followed by the number of
centisecs in multiple of 25 centisecs. The range is
25 to
4075 centisecs in multiples of 25 centisecs.
Defaults 1 second or 100 centisecs.
Command
Modes
INTERFACE-VRRP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.5(0.0) Added support for centisecs on the Z9000, S6000, S4820T,
S4810, and MXL.
Version 9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
Virtual Router Redundancy Protocol (VRRP)
1493