Dell S6000 - Verify

Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Added support for TFTP and SCP.
Version 7.6.1.0 Introduced on the S-Series.
Usage
Information
You must reload Dell Networking OS after executing this command.
Example
Dell#upgrade boot ?
all Upgrade both boot flash image and selector image
bootflash-image Upgrade boot flash image
bootselector-image Upgrade boot selector image
Dell#
verify
Validate the software image on the flash drive after the image has been transferred to the system, but
before the image has been installed.
Syntax verify { md5 | sha256 }[ flash:// ] img-file [hash-value]
Parameters
md5 Enter the md5 keyword to use the MD5 message-digest
algorithm.
sha256
Enter the sha256 keyword to use the SHA256 Secure Hash
Algorithm
flash:// (Optional). Enter the flash:// keyword. The default is to
use the flash drive. You can just enter the image file name.
img-file Enter the name the Dell Networking software image file to
validate.
hash-value (Optional). Enter the relevant hash published on i-Support.
Defaults flash drive
Command
Modes
EXEC mode
Command
History
Version 9.5.(0.0)
Introduced on the Z9000, S6000, S4820T, S4810, MXL
Usage
Information
You can enter this command in the following ways:
• verify md5 flash://img-file
• verify md5 flash://img-file <hash-value>
78
File Management