Dell S6000 - Fip-Snooping Max-Sessions-Per-Enodemac

Parameters
fc-map-value Enter the FC-MAP value FIP snooping uses. The range is
from 0EFC00 to 0EFCFF.
Defaults 0x0EFC00
Command
Modes
• CONFIGURATION
• VLAN INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
fip-snooping max-sessions-per-enodemac
Configure the maximum session limit per ENode MAC address.
Syntax
fip-snooping max—sessions—per—enode—mac max-sessions-value
To return the configured maximum sessions to the default value, use the no fip-
snooping max—sessions—per—enode—mac
command.
Parameters
max-sessions-
value
Enter the maximum number of sessions allowed per ENode
MAC address. The range is from 1 to 64.
Defaults 32
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2) Introduced on the S4810 and S4820T.
FCoE Transit
569