Dell S6000 - Show Ip Dhcp Configuration

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
show ip dhcp configuration
Display the DHCP configuration.
S6000
Syntax
show ip dhcp configuration [global | pool name]
Parameters
pool name Display the configuration for a DHCP pool.
global Display the DHCP configuration for the entire system.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
show ip dhcp conflict
Display the address conflict log.
S6000
Syntax
show ip dhcp conflict address
Parameters
address Display a particular conflict log entry.
Defaults none
Command
Modes
EXEC Privilege
536
Dynamic Host Configuration Protocol (DHCP)