Dell S6000 - Debug Ip Bgp Soft-Reconfiguration

in (OPTIONAL) Enter the keyword in to view BGP notifications
received from neighbors.
out (OPTIONAL) Enter the keyword out to view BGP
notifications sent to neighbors
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
To remove all configured debug commands for BGP, enter the no debug ip bgp
command.
debug ip bgp soft-reconfiguration
Enable soft-reconfiguration debug.
S6000
Syntax
debug ip bgp {ip-address | peer-group-name} soft-
reconfiguration
To disable, use the no debug ip bgp {ip-address | peer-group-name}
soft-reconfiguration command.
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-
name
(OPTIONAL) Enter the name of the peer group to disable or
enable all routers within the peer group..
Defaults Disabled
Command
Modes
EXEC Privilege
356
Border Gateway Protocol