Dell S6000 - Show Port-Channel-Flow

Gi 3/1 (Down)
Gi 3/2 (Up)
Dell#
Related
Commands
show lacp — displays the LACP matrix.
show port-channel-flow
Display an egress port in a given port-channel flow.
S6000
Syntax
show port-channel-flow outgoing-port-channel number incoming-
interface interface {source-ip address destination-ip address}
| {source-port number destination-port number} | {source-mac
address destination-mac address {vlan vlanid | ether-type}}
Parameters
outgoing-port-
channel
number
Enter the keywords outgoing-port-channel then the
number of the port channel to display flow information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
incoming-
interface
interface
Enter the keywords incoming-interface then the
interface type and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
source-ip
address
Enter the keywords source-ip then the IP source address
in IP address format.
destination-ip
address
Enter the keywords destination-ip then the IP
destination address in IP address format.
source-port
number
Enter the keywords source-port then the source port
number. The range is from 1 to 65536. The default is None.
destination-
port number
Enter the keywords destination-port then the
destination port number. The range is from 1 to 65536. The
default is
None.
source-mac
address
Enter the keywords source-mac then the MAC source
address in the nn:nn:nn:nn:nn:nn format.
destination-
mac address
Enter the keywords destination-mac then the MAC
destination address in the nn:nn:nn:nn:nn:nn format.
vlan vlan-id Enter the keywords vlan then the VLAN-id. The range is
from 0 to 4094.
ether-type Enter the keywords ether-type in the XX:XX format.
Interfaces
699