Dell S6000 - Radius-Server Vrf

Related
Commands
login authentication — sets the database to be checked when a user logs in.
radius-server key — sets an authentication key for RADIUS communications.
radius-server retransmit — sets the number of times the RADIUS server attempts to
send information.
radius-server timeout — sets the time interval before the RADIUS server times out.
radius-server vrf
Create an association between a RADIUS server group and a VRF and source interface..
Syntax
radius-server vrf vrf-name [source-interface interface]
To delete the association between a RADIUS server group and a VRF and source
interface, use the no radius-server vrf vrf-name [source-interface
interface] command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
associate a RADIUS server group with that VRF.
interface Enter the following keywords and slot/port or number
information:
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16838.
• For the Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command
Modes
RADIUS SERVER GROUP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
Security
1255