Dell S6000 - Service-Class Dot1 P-Mapping

service-class dot1p-mapping
Configure a service-class criterion based on a dot1p value.
S6000
Syntax
service-class dot1p-mapping {dot1p0 queue | dot1p1 queue |
dot1p2 queue | dot1p3 queue | dot1p4 queue| dot1p5 queue |
dot1p6 queue | dot1p7 queue}
Parameters
queue Enter a value from 0 to 7.
Defaults For each dot1p Priority, the default CoS queue value is:
• Dot1p Priority : 0 1 2 3 4 5 6 7
• Queue : 2 0 1 3 4 5 6 7
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
To apply dot1p-queue-mapping, use the service-class dynamic dot1p
command.
Related
Commands
show qos dot1p-queue-mapping — displays the dot1p priority to queue mapping
on the switch.
show qos dot1p-queue-mapping
Displays the dot1p priority to queue mapping on the switch.
S6000
Syntax
show qos dot1p-queue-mapping
Defaults
• dot1p Priority: 0 1 2 3 4 5 6 7
• Queue: 2 0 1 3 4 5 6 7
1108
Quality of Service (QoS)