show processes memory (S-Series) — displays CPU usage information based on
processes running in an S-Series.
show processes ipc flow-control
Display the single window protocol queue (SWPQ) statistics.
S6000
Syntax
show processes ipc flow-control [cp]
Syntax
show processes ipc flow-control [cp | rp1 | rp2 | stack-unit]
Parameters
cp (OPTIONAL) Enter the keyword cp to view the control
processor’s SWPQ statistics.
Parameters
cp (OPTIONAL) Enter the keyword cp to view the control
processor’s SWPQ statistics.
rp1 (OPTIONAL) Enter the keyword rp1 to view the Control
Processor’s SWPQ statistics on Route Processor 1.*
rp2 (OPTIONAL) Enter the keyword rp2 to view the Control
Processor’s SWPQ statistics on Route Processor 2.*
stack-unit (OPTIONAL) Enter the keyword stack-unit followed by the
stack-unit number to view the Control Processor’s SWPQ
statistics on the specified stack-unit.*
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
126
Control and Monitoring
To Next Page
Loading...
