Dell S6000 - Show System

LACP 0 0x00000000 0x00000000 0x8000383f 0x00000000 35
DHCP 0 0x00000000 0x00000000 0x800000c2 0x0000c000 37
V6RAD 0 0x00000433 0x00030000 0x00000000 0x00000000 0
Unidentified Client0 0x006e0002 0x00000000 0x00000000
0x00000000 0
Dell#
show system
Display the status of all stack members or a specific member.
S6000
Syntax
show system [brief | stack-unit unit-id [disabled—ports] |
stack-ports {status | topology}]
Parameters
brief (OPTIONAL) Enter the keyword brief to view an
abbreviated list of system information.
stack-unit unit-
id
(OPTIONAL) Enter the keywords stack-unit then the stack
member ID for information on that stack member.
The unit
ID range for the S6000 is from 0 to 5.
stack-unit unit-
id disabled-
ports
(OPTIONAL) Enter the keyword stack-unit followed by
stack member ID for the information on that stack number
and followed by the disabled-ports for the information on
the ports that are disabled.
stack-ports
status |
topology
(OPTIONAL) Enter the keywords stack-ports for
information about the status or topology of the S4810 stack
ports.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0) Added support for the disabled-ports parameter .
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
132
Control and Monitoring