Dell S6000 - Show Running-Config

Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Example
Dell#show os-version
RELEASE IMAGE INFORMATION :
---------------------------------------------------------------
------
Platform Version Size ReleaseTime
S-Series: SI 9-4(0-50) 49100764 Mar 6 2014 23:47:48
TARGET IMAGE INFORMATION :
---------------------------------------------------------------
------
Type Version Target checksum
runtime 9-4(0-50) Control Processor passed
BOOT IMAGE INFORMATION :
---------------------------------------------------------------
------
Type Version Target checksum
boot flash 3.1.1.3 Control Processor passed
BOOTSEL IMAGE INFORMATION :
---------------------------------------------------------------
------
Type Version Target checksum
boot selector 3.1.0.2 Control Processor passed
FPGA IMAGE INFORMATION :
---------------------------------------------------------------
------
Card FPGA Name Version
Stack-unit 0 S6000 SYSTEM CPLD 10
Stack-unit 0 S6000 MASTER CPLD 12
Stack-unit 0 S6000 SLAVE CPLD 10
Dell#
Usage
Information
NOTE: A filepath that contains a dot ( . ) is not supported.
show running-config
Display the current configuration and display changes from the default values.
S6000
Syntax
show running-config [entity] [configured] [status]
Parameters
entity (OPTIONAL) To display that entity’s current (non-default)
configuration, enter one of the following keywords:
NOTE: If you did not configure anything that entity,
nothing displays and the prompt returns.
File Management
67