Dell S6000 - Show Cam-Acl

Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.2.1 Introduced on the S-Series.
Version 8.4.2.0 Introduced on the E-Series TeraScale.
Version 7.8.1.0 Introduced on the C-Series.
Example
Dell#show cam-acl-egress
-- Chassis Egress Cam ACL --
Current Settings(in block sizes)
L2Acl : 1
Ipv4Acl : 1
Ipv6Acl : 2
-- Stack unit 0 --
Current Settings(in block sizes)
L2Acl : 1
Ipv4Acl : 1
Ipv6Acl : 2
Dell#show cam-acl
Related
Commands
cam-acl — configures CAM profiles to support IPv6 ACLs.
show cam-acl
Show space allocated for IPv6 ACLs.
S6000
Syntax
show cam-acl
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
IPv6 Access Control Lists (IPv6 ACLs)
779