Dell S6000 - Default Logging Monitor

E-Series legacy
command
Related
Commands
logging console — sets the logging console parameters.
default logging monitor
Return to the default settings for messages logged to the terminal.
S6000
Syntax
default logging monitor
Defaults level = 7 or debugging
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Related
Commands
logging monitor — sets the logging monitor parameters.
terminal monitor — sends system messages to the terminal/monitor.
default logging trap
Return to the default settings for logging messages to the Syslog servers.
S6000
Syntax
default logging trap
Defaults level = 6 or informational
Simple Network Management Protocol (SNMP) and Syslog
1361