Dell S6000 - Hardware Commands; Clear Hardware Stack-Unit

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Usage
Information
You cannot enter this command on a Master or Standby unit.
The system reboots when the off-line diagnostics complete. This reboot is an
automatic process. A warning message appears when the offline stack-unit
command is implemented.
Warning - Diagnostic execution will cause stack-unit to reboot
after completion of diags.
Proceed with Offline-Diags [confirm yes/no]:y
Related
Commands
show environment (S-Series) — views the S-Series system component status (for
example, temperature, voltage).
Hardware Commands
These commands display information from a hardware sub-component or ASIC.
clear hardware stack-unit
Clear statistics from selected hardware components.
S6000
Syntax
clear hardware stack-unit id {counters | unit 0–0 counters |
cpu data-plane statistics | cpu i2c statistics | cpu party-bus
statistics | cpu sata-interface statistics | stack-port 0–127}
Parameters
stack-unit id Enter the keywords stack-unit then a number to select a
particular stack member and then enter one of the following
command options to clear a specific collection of data.
The
range is 0 to 5.
counters Enter the keyword counters to clear the counters on the
selected stack member.
unit number
counters
Enter the keyword unit along with a port-pipe number,
then the keyword counters to clear the counters on the
selected port-pipe. The range is 0 to 0 for the S6000.
cpu data-plane
statistics
Enter the keywords cpu data-plane statistics to clear
the data plane statistics.
Debugging and Diagnostics
507