Dell S6000 - Show Storm-Control Multicast

show storm-control multicast
Display the storm control multicast configuration.
S6000
Syntax
show storm-control multicast [interface]
Parameters
interface (OPTIONAL) Enter one of the following interfaces to display
the interface specific storm control configuration:
• For Fast Ethernet, enter the keyword Fastethernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
Defaults none
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Example
Dell#show storm-control multicast gigabitethernet 1/0
Multicast storm control configuration
Interface Direction Packets/Second
-----------------------------------------
Gi 1/0 Ingress 5
Dell#
Storm Control
1387